For Hot Rolled stainless steel the old BS1449 and BS1501 standards have been replaced by EN Standards:
EN10088-2 Replaces BS1449-Part 2: 1983
EN10028-7 Replaces BS1501-Part3: 1990
EN10095 Covers Heat Resisting Grades
EN10259 & ISO 9445: Tolerances for COLD Rolled material (Sheets, plate, coil) up to 6.5mm thick
EN10029 & ISO 18286: Tolerances for 'Quarto' Hot Rolled Plate 3mm thick and above
EN10051 & Now ISO 9445 / 9444: Tolerances for Continuosly Produced (CPP) Hot Rolled Plate
Material Certification
Where multi-certification is required, a combination of EN10088-2, EN10028-7, EN10029 or 10051 will appear together with the appropriate ASTM Standards.
Tolerances
For Cold Rolled Plate please refer to the datasheet on cold rolled
Note that in this Datasheet there are two sets of tolerances tables – One set for Quarto Plate to EN10029 and one set for CPP plate to EN10051
For CPP there are 3 categories of tolerances according to the grade where:
B = Ferritic & Martensitic Grades
C = Austenitic Grades without Mo
D = Austenitic Grades with Mo
This Data is indicative only and must not be seen as a substitute for the full specification from which it is drawn. In particular, the mechanical property requirements vary widely with temper, product and product dimensions. The information is based on our present knowledge and is given in good faith. However, no liability will be accepted by the Company is respect of any action taken by any third party in reliance thereon.
Any advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. Any contract between the Company and a customer will be subject to the Company’s Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.